Dark Crystal

The junction box will be placed there and all wires will return there below it .


I made this small notch to pass the Parallel LCD wire to have the least possible of visible wire.


I cut out this panel to shut the rear side of case. This case back panel also will be painted with black paint to get a mirror effect.


The second acrylic part will be useful to fix the rear fan to extract some heat out of the case.


All the clamp holes of the panels were countersunk with this bit so that the screw heads are flush.


The rear side in place with the fan hole.


I cut the window out a 6 mm thick acrylic piece to fit well with the case edge I made in the wood, then the window and wood surfaces will be on the same level.


I searched for a long time for black screws to fix it and I first wanted screws with a head milled for Allen wrench. The only place where I could buy some of them sold them by 1000 pieces boxes. I then had decided to use the same screws which were used for the fixing of the structure of the case but I needed to shorten them with the Dremel because they were too long.


Black Paint on every panel. 3 coats were necessary in order to make good opacity with the sources of light which will be placed behind these panels.


And here you can see the shiny Darkcrystal effect.