Testing and Results

We place our test rigs under load using the Small FFTs stress test in the free application Prime95, as this test is designed to place maximum load on the CPU and minimum load on the system's memory. We use the freeware application Core Temp to measure the temperature of our CPUs, as it reads data from the DTS (digital thermal sensor) embedded inside each core of Intel's modern processors and thus provides as accurate a reading as possible. We always take the temperature of the hottest core for consistency, and do so after 15 minutes of the Prime95 test, which is enough time for temperatures to plateau.

The results provided are the delta T results; the difference between the recorded CPU temperature and ambient temperature at the time of testing. Our labs are not temperature controlled, so this provides the most accurate method of comparison for coolers tested on different days.

Any cooler that causes one of our CPUs to hit its Tj Max, the maximum temperature at which the CPU will operate before downclocking itself, is considered a fail. If a cooler has multiple available fan speeds, we retest at appropriate speeds to highlight the differences. Unless otherwise stated, closed loop liquid coolers are installed with their fans as exhausts. Finally, any cooler that is PWM (pulse width modulation) capable is tested both at full speed and using the standard PWM setting on our motherboards.

Intel LGA1155 Test System

• Intel Core i7-2600K overclocked to 4.4GHz (44 x 100MHz) using a vcore of 1.275V
  
• Asus Maximus V Formula
  
• 2 x 2GB Crucial Ballistix 1,600MHz low-profile RAM
  
• PNY Performance 60GB SSD
  
• Corsair HX750W PSU

Intel LGA2011 Test System

• Intel Core i7-3960X overclocked to 4.2GHz (44 x 100MHz) using a vcore of 1.275V
  
• X79A-GD45
  
• 4 x 4GB G.Skill Ripjaw 1,6000MHz RAM
  
• Samsung SSD 830 128GB
  
• Enermax Revolution 87+ 750W PSU

**Our previous LGA2011 system had to be rebuilt in time for this review due to hardware failure - a big thanks to Overclockers UK who sent us a replacement LGA2011 motherboard. As such, we've only had time to re-test a select few coolers for the LGA2011 results. This is a temporary system before we upgrade a number of our long-term test rigs in the not too distant future**

The systems run Windows 7 64-bit, are built inside a Corsair Carbide 500R and use an AMD ATI Radeon HD 5770 1GB. Coolers are tested with both of the case's side panels fully attached and with its two 120mm front intake fans and rear 120mm exhaust fan operating at consistent speeds, providing interior airflow that is more realistic than a benchtable or our previous set-up. The cases have been cable tidied and had their front drive cages removed to optimise airflow.




Read our performance analysis on the next page.